raidcom modify pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E30 6003 The specified pool is for Thin Image or Copy-on-
Write Snapshot.
CMDRJE Executing 2E30 6005 The specified pool must be assigned two user-
defined thresholds to.
CMDRJE Executing 2E30 600D On the specified pool, Tier Reallocation is not
enabled.
CMDRJE Executing 2E30 600F The specified operation cannot be performed
because the specified pool is not for Dynamic
Provisioning.
CMDRJE Executing 2E30 6010 Active flash cannot be enabled because an SSD
medium does not exist on Tier 1 of Dynamic
Provisioning.
CMDRJE Executing 2E30 6011 Active flash cannot be enabled or disabled because
the pool is for Dynamic Provisioning.
CMDRJE Executing 2E30 6012 The operation of Dynamic Tiering cannot be
performed because the specified pool is used for
Data Direct Mapping.
Get Command
Status
Async 2E30 6014 The operation cannot be performed because the
specified pool is for active flash.
Get Command
Status
Async 2E31 6003 The operation cannot be performed because the
specified pool is for Dynamic Provisioning for
Mainframe.
CMDRJE Executing 2E31 6004 The specified pool includes the different RAID
levels of volumes although the pool cannot include
those volumes together.
CMDRJE Executing 2E31 6005 The specified pool includes external volumes
although the pool cannot include those volumes
together.
CMDRJE Executing 2E31 6006 The specified pool cannot be used for a Dynamic
Tiering or active flash.
CMDRJE Executing 2E31 9000 The capacity that can be used by the installed
program products exceeds the maximum.
CMDRJE Executing 2E31 9001 The program product is not installed.
CMDRJE Executing 2E3F 8000 The specified operation is not supported in the
current microcode version.
CMDRJE Executing 2EE7 0001 Pool ID is not installed.
CMDRJE Executing 2EE7 0011 An internal error occurred at the pool operation.
Call Hitachi Data Systems customer support.
CMDRJE Executing 2EE7 00EE The command cannot be accepted. After a while,
execute the same command.
Troubleshooting
9-77
Command Control Interface User and Reference Guide
To Next Page
Loading...
