Hitachi HUS VM - Page 400

raidcom modify pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E21 8103 The operation cannot be performed because of the
insufficient capacity of shared memory.
Get Command
Status
Async 2E21 810A The shared memory is not installed.
Get Command
Status
Async 2E21 9000 The program product is not installed.
CMDRJE Executing 2E21 9014 Data Retention Utility program product is not
installed.
CMDRJE
Get Command
Status
Executing/
Async
2E22 0001 The specified LDEV is already defined.
Get Command
Status
Async 2E23 0001 The number exceeds the maximum number of
LDEVs that can be created in the current system
configuration.
CMDRJE
Get Command
Status
Executing/
Async
2E23 0008 The number of specified deduplication system data
volumes exceeds the maximum limit.
CMDRJE Executing 2E23 7201 The specified SSID number exceeds the maximum
limit.
Get Command
Status
Async 2E30 0020 The specified SSID is already used in the another
CU.
Get Command
Status
Async 2E30 0021 The SSID is already allocated to the CU.
Get Command
Status
Async 2E30 0025 The specified volume is used as an alias device in
Compatible PAV.
Get Command
Status
Async 2E30 0026 An LDEV of another emulation type is allocated in
the range where the number is divided into each
32 LDEVs.
CMDRJE Executing 2E30 006E The Dynamic Tiering or active flash operation
cannot be performed to the pool because the
specified pool contains the external volumes whose
cache mode is invalid.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0071 A pool volume cannot be operated because the
LDEV of the resource group different from the
resource group of the pool volume belonging to the
specified pool is specified.
Get Command
Status
Async 2E30 009A The page reservation cannot be set on the
specified LDEV with the specified operation.
Get Command
Status
Async 2E30 4119 The operation cannot be performed because the
number of V-VOLs that can be created in the
system exceeds the maximum number.
CMDRJE Executing 2E30 6000 The threshold value 1 is out of range.
9-76
Troubleshooting
Command Control Interface User and Reference Guide