Hitachi HUS VM - Page 403

raidcom delete pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E10 600F The operation cannot be performed because the
current capacity rate exceeds the value of
maximum reserved capacity rate.
Get Command
Status
Async 2E10 6010 It cannot be deleted because the pool volume is
set in the state of being deterred deleting.
Get Command
Status
Async 2E10 6011 Deleting operation cannot be performed because it
is being discarded pages.
Get Command
Status
Async 2E10 601F The deduplication function is set to be enabled for
the specified pool.
Get Command
Status
Async 2E10 8002 The specified operation is not supported in the
current microcode version.
Get Command
Status
Async 2E11 001F The operation cannot be performed because a Thin
Image pair or a Copy-on-Write Snapshot pair
remains or the association with a Dynamic
Provisioning virtual volume exists.
Get Command
Status
Async 2E11 0020 The operation cannot be performed because a Thin
Image pair or a Copy-on-Write Snapshot pair is
being deleted or a Dynamic Provisioning virtual
volume is being deleted.
Get Command
Status
Async 2E11 0021 The operation cannot be performed because a pool
volume of a specified pool is being formatted.
CMDRJE
Get Command
Status
Executing/
Async
2E11 6003 The pool is not in the status where the pool can be
deleted or a pool volume can be deleted.
Get Command
Status
Async 2E11 8003 The operation cannot be performed because the
power supply is switched off.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2E13 0002 The operation cannot be performed because the
specified LDEV is linked with the virtual volume
having the Data Direct Mapping attribute.
Get Command
Status
Async 2E13 6006 The last SSD medium on Tier 1 of active flash
cannot be deleted.
Get Command
Status
Async 2E13 6009 The operation cannot be performed because the
pool capacity is insufficient for Data Direct
Mapping.
CMDRJE Executing 2E20 0003 The specified LDEV is not registered to the pool.
Get Command
Status
Async 2E20 0003 The operation cannot be performed because the
pool volume is not of a specified pool.
CMDRJE
Get Command
Status
Executing/
Async
2E20 6000 Pool ID is not installed.
Troubleshooting
9-79
Command Control Interface User and Reference Guide