raidcom delete pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E21 8106 The operation cannot be performed because the
shared memory is not initialized.
CMDRJE Executing 2E23 0008 The number of specified LDEVs is invalid.
CMDRJE Executing 2E30 0052 The specified LDEV cannot be deleted because it is
a top VOL of the pool.
CMDRJE Executing 2E30 6003 The specified pool is a pool for Thin Image or
Copy-on-Write Snapshot.
CMDRJE Executing 2EE7 00EE The command cannot be accepted. After a while,
execute the same command.
CMDRJE Executing 2EE7 00F9 Pool ID is not installed.
CMDRJE Executing 2EE7 FEEC An internal error occurred.
Call Hitachi Data Systems customer support.
CMDRJE Executing 2EF3 6002 The specified parameter is invalid. Check the
Command Control Interface Command Reference.
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
Table 9-46 SSB codes returned by raidcom add snap_pool
raidcom add snap_pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E00 0000 The LDEV number is out of settable range.
CMDRJE Executing 2E00 6000 Pool ID is out of range.
CMDRJE Executing 2E00 6001 The type of pool is invalid.
CMDRJE Executing 2E00 6002 The maximum reserve ratio for V-VOL is out of
range.
Get Command
Status
Async 2E10 000C The operation cannot be performed because a
SATA-E drive in the state of quick formatting is in
the specified LDEV.
Get Command
Status
Async 2E10 0009 The specified LDEV is in the state of blocked.
CMDRJE Executing 2E10 0011 The specified LDEV is in the state of blocked, or
not installed.
Get Command
Status
Async 2E10 0050 Thin Image cannot be used because there are not
enough cache management devices to create
pairs.
9-80
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
