Hitachi HUS VM - Page 405

raidcom add snap_pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E10 0102 The pool cannot be created because there are not
enough resources (VDEV) depending on cache
management devices.
Get Command
Status
Async 2E10 600D The operation cannot be performed because the
pool volume is being deleted.
Get Command
Status
Async 2E11 005F The operation failed because accelerated
compression of the parity group to which the
specified LDEV belongs is enabled and the other
LDEV in the parity group is being used for the
other pool.
Get Command
Status
Async 2E11 0108 The specified LDEV is the LDEV configuring the
RAID configuration which cannot be used for the
pool volume.
CMDRJE
Get Command
Status
Executing/
Async
2E11 6003 The pool is not in the status where the pool
volume can be added.
Get Command
Status
Async 2E11 8003 The operation cannot be performed because the
power supply is switched off.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2E20 0000 The specified LDEV is not installed.
Get Command
Status
Async 2E21 8103 The operation cannot be performed because the
memory capacity of the shared memory is
insufficient.
Get Command
Status
Async 2E21 8106 The operation cannot be performed because the
shared memory for Thin Image or Copy-on-Write
Snapshot is not initialized.
CMDRJE Executing 2E21 9007 Thin Image or Copy-on-Write Snapshot program
product is not installed.
Get Command
Status
Async 2E22 0005 Exceeded the number of pool volume that can be
registered in a pool.
Get Command
Status
Async 2E22 000D The larger number of drive types than the
supported configuration cannot be added to the
specified pool.
Get Command
Status
Async 2E22 6100 Pool volume cannot be registered because the
drive type of the specified LDEV is different from
the other pool volume type, or the drive type in
the pool exceeds the three.
CMDRJE Executing 2E23 0008 The number of specified LDEVs is invalid.
Get Command
Status
Async 2E30 0000 The emulation type of the specified LDEV cannot
be used as a pool VOL.
Troubleshooting
9-81
Command Control Interface User and Reference Guide