raidcom add snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E10 005C A Thin Image pair cannot be operated because
changing the model and the serial number in the
virtual storage machine of the specified P-VOL is in
progress.
CMDRJE Executing 2E10 005D A Thin Image pair cannot be operated because
changing the model and the serial number in the
virtual storage machine of the specified S-VOL is in
progress.
CMDRJE Executing 2E10 0203 The operation failed because the setting of the T10
PI attribute is not match between the specified P-
VOL and the specified S-VOL.
CMDRJE Executing 2E10 0205 A pair cannot be created because the page discard
(reclaim zero pages) is being executed by a SCSI
command from the Host to the specified S-VOL.
CMDRJE Executing 2E10 0206 A Thin Image pair cannot be created because the
Dynamic Provisioning V-VOL in capacity expanding
is specified as the S-VOL of a Thin Image pair.
CMDRJE Executing 2E10 0211 The command ends abnormally because the
volume which is being deleted is specified.
CMDRJE Executing 2E10 2300 A Thin Image pair or a Copy-on-Write Snapshot
pair with the specified consistency group ID cannot
be created due to one of the following reasons:
• The specified consistency group ID is used by
the ShadowImage.
• The number of pairs that can be defined in a
consistency group exceeds the maximum.
• The pair created by using the same P-VOL
already exists in the specified consistency
group.
CMDRJE Executing 2E10 2302 A Thin Image pair specifying CTG mode cannot be
created because the maximum number of
consistency groups has already been defined.
CMDRJE Executing 2E10 6018 A Thin Image pair cannot be created due to one of
the following reasons:
• The pool usage value exceeds the threshold
value.
• The specified pool is blocked.
CMDRJE Executing 2E10 8100 A Thin Image pair or a Copy-on-Write Snapshot
pair cannot be created because there are not
enough pair tables.
CMDRJE Executing 2E10 8101 A Thin Image pair or a Copy-on-Write Snapshot
pair cannot be created because there are not
enough differential tables.
9-88
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
