raidcom add snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
• The specified pool is not in the usable status.
• The license capacity has exceeded the
maximum.
• The control table for Thin Image is depleted.
• The number of pairs that can be created in a
snapshot tree has exceeded the maximum.
CMDRJE Executing 2E11 8003 The operation cannot be performed because
power-off is in progress.
CMDRJE Executing 2E11 800F The operation failed because multiple versions of
DKCMAIN microcode are included.
CMDRJE Executing 2E11 9701 A pair cannot be created because the specified
snapshot group contains Thin Image pairs with the
clone attribute and without the clone attribute.
CMDRJE Executing 2E11 9702 A pair cannot be created in the same consistency
group as the Thin Image pair which uses the
specified P-VOL as an S-VOL.
CMDRJE Executing 2E13 0000 A Thin Image pair or a Copy-on-Write Snapshot
pair cannot be created because the specified P-VOL
is a LUSE volume.
CMDRJE Executing 2E13 6003 A pair cannot be created because there is a pair in
the specified primary volume, which is using a
different pool number from the specified pool
number.
CMDRJE Executing 2E13 6004 The specified pair operation cannot be performed
for the specified pool.
CMDRJE Executing 2E13 9900 The consistency group to be used in the specified
Snapshot Group is in one of the following status:
• The number of pairs that can be defined in a
consistency group exceeds the maximum.
• The pair created by using the same P-VOL
already exists in the specified consistency
group.
CMDRJE Executing 2E20 0000 The specified LDEV is not defined.
CMDRJE Executing 2E20 0008 The command ends abnormally because an
unmounted volume is specified as the P-VOL of a
Thin Image pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E20 0009 The command ends abnormally because the
blocked volume is specified as the P-VOL of a Thin
Image pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E20 000A The command ends abnormally because the
volume in formatting is specified as the P-VOL of a
Thin Image pair or a Copy-on-Write Snapshot pair.
9-90
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
