raidcom modify snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
than PSUS or PSUE when the volume is shared
between the P-VOL of a Thin Image/Copy-on-Write
Snapshot pair and the P-VOL of a ShadowImage
pair.
CMDRJE Executing 2E10 004C The Thin Image pair or the Copy-on-Write Snapshot
pair cannot be restored because the Thin Image pair
or the Copy-on-Write Snapshot pair status is other
than PSUS when the volume is shared between the
P-VOL of a Thin Image/Copy-on-Write Snapshot pair
and the S-VOL of a ShadowImage pair.
CMDRJE Executing 2E10 004D A Snapshot data cannot be obtained because the
TrueCopy asynchronous pair status is other than
PSUS or PSUE when the volume is shared between
the P-VOL of a Thin Image/Copy-on-Write Snapshot
pair and the S-VOL of a TrueCopy asynchronous
pair.
CMDRJE Executing 2E10 004E The operation cannot be performed because the P-
VOL of the ShadowImage pair on which the Quick
Restore is being operated is specified as the P-VOL
of a Thin Image pair or a Copy-on-Write Snapshot
pair.
CMDRJE Executing 2E10 0051 The pair operation cannot be performed because the
volume which specifies the volume using two
mirrors cannot accept the specified command in the
following configurations using three Universal
Replicator sites.
• 3DC multi target configuration
• 3DC cascade configuration
• Delta resync configuration
CMDRJE Executing 2E10 0052 A Thin Image pair operation cannot be performed
because the pair status of all Thin Image pairs
sharing the specified P-VOL is PSUE.
CMDRJE Executing 2E10 0056 The specified volume cannot be used for the Thin
Image pair operation because the virtual LDEV ID is
deleted.
CMDRJE Executing 2E10 005B The Thin Image pair operation cannot be performed
because the virtual storage machine of the specified
P-VOL is different from the virtual storage machine
of the specified S-VOL.
CMDRJE Executing 2E10 0061 The Thin Image pair operation cannot be performed
because the virtual LDEV ID of the specified volume
is deleted.
CMDRJE Executing 2E10 6018 A Thin Image pair cannot be created due to one of
the following reasons:
• The pool usage value exceeds the threshold
value.
Troubleshooting
9-95
Command Control Interface User and Reference Guide
To Next Page
Loading...
