raidcom modify snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
• The specified pool is blocked.
CMDRJE Executing 2E10 6019 A Snapshot data cannot be obtained because the
pool or the pool-VOL is blocked.
CMDRJE Executing 2E10 8100 A Thin Image pair or a Copy-on-Write Snapshot pair
cannot be created because there are not enough
pair tables.
CMDRJE Executing 2E10 8101 A Thin Image pair or a Copy-on-Write Snapshot pair
cannot be created because there are not enough
differential tables.
CMDRJE Executing 2E10 8102 A pair cannot be created because there is not
enough free shared memory space.
CMDRJE Executing 2E10 9700 The command ends abnormally because other than
the raidcom add snapshot command is issued for
the volume other than the Thin Image pair or the
Copy-on-Write Snapshot pair.
CMDRJE Executing 2E10 9701 The command ends abnormally because the pair is
in the state of unacceptable the command.
CMDRJE Executing 2E10 9702 The Thin Image pair or the Copy-on-Write Snapshot
pair cannot be restored because the volume is
shared between the P-VOL of a Thin Image/Copy-
on-Write Snapshot pair and the S-VOL of a
TrueCopy pair.
CMDRJE Executing 2E10 9703 The Thin Image pair or the Copy-on-Write Snapshot
pair cannot be restored because the volume is
shared between the P-VOL of a Thin Image/Copy-
on-Write Snapshot pair and the S-VOL of a
Universal Replicator pair.
CMDRJE Executing 2E10 9704 The Thin Image pair or the Copy-on-Write Snapshot
pair cannot be restored due to one of the following
reasons:
• Snapshot data of a restore target Thin Image
pair or Copy-on-Write Snapshot pair is being
obtained per consistency group.
• Snapshot data of a different pair whose primary
volume is the restore target P-VOL of a Thin
Image pair or a Copy-on-Write Snapshot pair is
being obtained per consistency group.
CMDRJE Executing 2E10 9710 The clone attribute of the specified Thin Image pair
is enabled.
CMDRJE Executing 2E10 9713 The operation cannot be performed because the
snapshot tree is being deleted.
CMDRJE Executing 2E10 9714 The specified snapshot group name cannot be
changed because it is already registered.
9-96
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
