raidcom modify snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E10 9800 An error occurred at the operation of Thin Image
due to one of the following reasons:
• The LDEV number specified for the P-VOL or the
S-VOL is incorrect.
• The LDEV specified as the P-VOL or the S-VOL
is not paired.
• The pair of the specified P-VOL or the S-VOL is
not ready to perform the specified operation.
• The specified Snapshot ID (MU number) is
wrong.
• The specified Snapshot ID (MU number) is
already used.
• The specified pool is not in the usable status.
• The license capacity has exceeded the
maximum.
• The control table for Thin Image is depleted.
• The snapshot group name cannot be changed.
CMDRJE Executing 2E11 8003 The operation cannot be performed because power-
off is in progress.
CMDRJE Executing 2E11 9703 The pair operation cannot be performed because the
status of the pair that uses the specified P-VOL as
an S-VOL is not PSUS.
CMDRJE Executing 2E11 9705 The command was rejected because pairs in the
status other than PAIR exist under the specified
pair.
CMDRJE Executing 2E20 0000 The specified LDEV is not defined.
CMDRJE Executing 2E20 0008 The command ends abnormally because an
unmounted volume is specified as the P-VOL of a
Thin Image pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E20 0009 The command ends abnormally because the blocked
volume is specified as the P-VOL of a Thin Image
pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E20 000A The command ends abnormally because the volume
in formatting is specified as the P-VOL of a Thin
Image pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E21 8107 The command ends abnormally because the shared
memory (FC, TPF, or Extension1) is not added for
necessary capacity or maintenance work is being
performed.
CMDRJE Executing 2E21 8108 The shared memory for Thin Image or Copy-on-
Write Snapshot is not installed.
CMDRJE Executing 2E21 810A The shared memory is not installed.
Troubleshooting
9-97
Command Control Interface User and Reference Guide
To Next Page
Loading...
