raidcom modify snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing 2E21 9010 The program product is not installed.
CMDRJE Executing 2E21 9306 The virutal LDEV ID for a virtual storage machine is
not defined on the specified LDEV.
CMDRJE Executing 2E21 930A The virtual storage machine with the specified serial
number is not found.
CMDRJE Executing 2E30 000C The specified LDEV is used as a quorum disk.
CMDRJE Executing 2E30 0079 The Thin Image pair or the Copy-on-Write Snapshot
pair cannot be restored because the volume that is
set the S-VOL Disable is specified as the P-VOL.
CMDRJE Executing 2E30 007A The command ends abnormally because the volume
other than OPEN-V is specified as the P-VOL of a
Thin Image pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E30 0081 The command ends abnormally because the
external volume mapped for the online data
migration is specified as the S-VOL of a Thin Image
pair or a Copy-on-Write Snapshot pair.
CMDRJE Executing 2E30 0090 The pair operation is rejected because the specified
volume as the primary volume is a reserved volume
for GAD, or the volume for the GAD pair which is in
the invalid status.
CMDRJE Executing 2E30 0091 The pair operation is rejected because the specified
volume as the secondary volume is a reserved
volume for GAD, or the volume for the GAD pair.
CMDRJE Executing 2E30 0099 The specified LDEV is a volume of which Data Direct
Mapping attribute is enabled.
CMDRJE Executing 2E30 0201 The specified LDEV is an external volume of which
Data Direct Mapping attribute is enabled.
CMDRJE Executing 2E30 0202 The specified LDEV is a virtual volume of which Data
Direct Mapping attribute is enabled.
CMDRJE Executing 2E3F 8000 The specified operation is not supported in the
current microcode version.
CMDRJE Executing 2EC6 FEEC An internal error occurred. Call Hitachi Data
Systems customer support.
CMDRJE Executing 2EF3 0002 The specified parameter is invalid. Check the
Command Control Interface Command Reference.
CMDRJE Executing B980 B903 The command was rejected because the selected
resource belongs to NAS_Platform_System_RSG.
9-98
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
