raidcom delete snapshot
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
PSUS or PSUE when the volume is shared between
the P-VOL of a Thin Image/Copy-on-Write
Snapshot pair and the S-VOL of a TrueCopy
asynchronous pair.
CMDRJE Executing 2E10 004E The operation cannot be performed because the P-
VOL of the ShadowImage pair on which the Quick
Restore is being operated is specified as the P-VOL
of a Thin Image pair or a Copy-on-Write Snapshot
pair.
CMDRJE Executing 2E10 0056 The specified volume cannot be used for the Thin
Image pair operation because the virtual LDEV ID
is deleted.
CMDRJE Executing 2E10 005B The Thin Image pair operation cannot be
performed because the virtual storage machine of
the specified P-VOL is different from the virtual
storage machine of the specified S-VOL.
CMDRJE Executing 2E10 0061 The specified volume cannot be used for the Thin
Image pair operation because the virtual LDEV ID
is deleted.
CMDRJE Executing 2E10 0204 The operation failed because the specified LDEV
which is holding the attribute of SLU is bind to the
LDEV which is holding the attribute of ALU.
CMDRJE Executing 2E10 6019 A Snapshot data cannot be obtained because the
pool or the pool-VOL is blocked.
CMDRJE Executing 2E10 9700 The command ends abnormally because other than
the raidcom add snapshot command is issued for
the volume other than the Thin Image pair or the
Copy-on-Write Snapshot pair.
CMDRJE Executing 2E10 9701 The command ends abnormally because the pair is
in the state of unacceptable the command.
CMDRJE Executing 2E10 9800 An error occurred at the operation of Thin Image
due to one of the following reasons:
• The LDEV number specified for the P-VOL or
the S-VOL is incorrect.
• The LDEV specified as the P-VOL or the S-VOL
is not paired.
• The pair of the specified P-VOL or the S-VOL is
not ready to perform the specified operation.
• The specified Snapshot ID (MU number) is
wrong.
• The specified Snapshot ID (MU number) is
already used.
• The specified pool is not in the usable status.
• The license capacity has exceeded the
maximum.
9-100
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
