Table 9-56 SSB codes returned by raidcom add dp_pool
raidcom add dp_pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E00 0000 The LDEV number is out of settable range.
CMDRJE Executing 2E00 6000 The value of pool ID is out of range.
CMDRJE Executing 2E00 6001 The type of pool is invalid.
CMDRJE Executing 2E00 6002 The maximum reserve ratio of V-VOL is out of
range.
CMDRJE Executing 2E00 6009 The threshold of the specified High water mark is
out of range.
CMDRJE Executing 2E00 600A The operation cannot be performed because the
specified threshold of Warning is larger than the
threshold of the specified High water mark.
Get Command
Status
Async 2E10 0009 The specified LDEV is in the state of blocked.
Get Command
Status
Async 2E10 000C The operation cannot be performed because a
SATA-E drive in the state of quick formatting is in
the specified LDEV.
CMDRJE Executing 2E10 0011 The specified LDEV is in the state of blocked, or not
installed.
Get Command
Status
Async 2E10 0102 The pool cannot be created because there are not
enough resources (VDEV) depending on cache
management devices.
Get Command
Status
Async 2E10 600D The operation cannot be performed because the
pool volume is being deleted.
Get Command
Status
Async 2E10 6029 The lowest tier cannot be added because either of
the following applies to the specified pool:
• The pool contains a volume for which capacity
saving is enabled.
• The deduplication function is enabled.
Get Command
Status
Async 2E10 8002 The specified operation is not supported in the
current microcode version.
Get Command
Status
Async 2E11 005F The operation failed because accelerated
compression of the parity group to which the
specified LDEV belongs is enabled and the other
LDEV in the parity group is being used for the
other pool.
Get Command
Status
Async 2E11 0108 The specified LDEV is the LDEV configuring the
RAID configuration which cannot be used for the
pool volume.
CMDRJE Executing/
Async
2E11 6003 The pool is not in the status where the pool volume
can be added.
9-114
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
