raidcom add dp_pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Get Command
Status
Async 2E11 8003 The operation cannot be performed because the
power supply is switched off.
Get Command
Status
Async 2E11 800F The operation cannot be performed because the
unsupported microcode version exists in the
system.
CMDRJE Executing 2E11 9400 The command cannot be accepted. After a while,
execute the same command.
Get Command
Status
Async 2E13 6009 The operation cannot be performed because the
pool capacity is insufficient for Data Direct
Mapping.
Get Command
Status
Async 2E20 0000 The specified LDEV is not installed.
Get Command
Status
Async 2E21 8103 The operation cannot be performed because the
memory capacity of the shared memory is
insufficient.
Get Command
Status
Async 2E21 8106 The operation cannot be performed because the
shared memory is not initialized.
CMDRJE Executing 2E21 9007 Dynamic Provisioning program product is not
installed.
Get Command
Status
Async 2E21 9014 Data Retention Utility program product is not
installed.
Get Command
Status
Async 2E22 0005 Exceeded the number of pool volume that can be
registered in a pool.
Get Command
Status
Async 2E22 000D The larger number of drive types than the
supported configuration cannot be added to the
specified pool.
Get Command
Status
Async 2E22 6100 Pool volume cannot be registered because the
drive type of the specified LDEV is different from
the other pool volume type, or the drive type in
the pool exceeds three.
CMDRJE Executing 2E23 0008 The number of specified LDEVs is invalid.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0000 The emulation type of the specified LDEV cannot
be used as a pool VOL.
Get Command
Status
Async 2E30 0007 The specified LDEV has the LU path definition.
Get Command
Status
Async 2E30 000C The specified LDEV is used as a quorum disk.
Get Command
Status
Async 2E30 000D The specified LDEV is used as a system disk.
Troubleshooting
9-115
Command Control Interface User and Reference Guide