Hitachi HUS VM - Page 440

raidcom add dp_pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E30 000E The specified LDEV is already used as a pool
volume.
Get Command
Status
Async 2E30 0010 The specified LDEV is a command device.
Get Command
Status
Async 2E30 0038 It cannot be used as a pool volume because the
size of the specified LDEV is less than 8GB.
Get Command
Status
Async 2E30 0039 Creating a pool or adding a pool volume cannot be
performed because CLPR is mixed in the specified
pool.
Get Command
Status
Async 2E30 005C The specified LDEV is used as a V-VOL.
Get Command
Status
Async 2E30 005D The specified LDEV is a volume of unsupported
Dynamic Tiering or active flash.
Get Command
Status
Async 2E30 005E The specified LDEV is used in another program
product.
CMDRJE Executing 2E30 006C An LDEV, whose emulation type is not available to
be mixed, is in the specified LDEVs.
Get Command
Status
Async 2E30 006E The operation cannot be performed for the
following reasons:
• The pool volumes to be added to the Dynamic
Tiering pool or active flash pool include
external volumes whose cache modes are
invalid.
• The Dynamic Provisioning pool includes both
external volumes whose cache modes are
invalid and internal volumes.
CMDRJE
Get Command
Status
Executing/
Async
2E30 0071 A pool volume cannot be added because the LDEV
of the resource group different from the resource
group of the pool volume to which the specified
pool belongs is specified.
Get Command
Status
Async 2E30 0074 The specified LDEV cannot be operated because it
is an external volume mapped for online data
migration.
Get Command
Status
Async 2E30 0085 The specified volume cannot be used as a pool
volume.
Get Command
Status
Async 2E30 0099 The specified LDEV is a volume of which Data
Direct Mapping attribute is enabled.
CMDRJE Executing 2E30 6000 The threshold value 1 is out of range.
Get Command
Status
Async 2E30 6004 The specified pool attribute differs from the pool
attribute of existed pool.
Get Command
Status
Async 2E30 6013 The LDEV that belongs to the parity group which
accelerated compression is enabled cannot be
9-116
Troubleshooting
Command Control Interface User and Reference Guide