raidcom modify port -ipv6_global_address
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 120E The command cannot be executed because the
iSCSI virtual port mode is ON.
Table 9-77 SSB codes returned by raidcom modify port -ipv6_global_address2
raidcom modify port -ipv6_global_address2
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 1039 The command device being used at the local CCI
exists under the port.
CMDRJE Executing B955 10C9 The same IPv6 address cannot be set to the same
port redundantly.
CMDRJE Executing B955 10FD If global address 1 for IPv6 is not set, you cannot
set global address 2 for IPv6 manually.
CMDRJE Executing B955 10FE The multicast address or the loop-back address
cannot be set as global address 2 for IPv6.
CMDRJE Executing B955 120E The command cannot be executed because the
iSCSI virtual port mode is ON.
Table 9-78 SSB codes returned by raidcom modify port -ipv6_local_address
raidcom modify port -ipv6_local_address
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 1039 The command device being used at the local CCI
exists under the port.
CMDRJE Executing B955 10B6 The invalid value is specified for the link local
address of IPv6.
CMDRJE Executing B955 10C9 The same IPv6 address cannot be set to the same
port redundantly.
CMDRJE Executing B955 120E The command cannot be executed because the
iSCSI virtual port mode is ON.
9-136
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
