raidcom modify port -add_iscsi_virtual_port
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE Executing B955 10B3 This command cannot be set due to one of the
following reasons:
• The network address, loop-back address,
broadcast address, or the IP address beginning
with 255 is set as the IPv4 address.
• No option is set when a virtual port in IPv4
mode was added. See the Command Control
Interface Command Reference.
CMDRJE Executing B955 10B8 The multicast address or the loop-back address
cannot be set as global address 1 for IPv6.
CMDRJE Executing B955 10B9 The multicast address or the loop-back address
cannot be set as the default gateway for IPv6.
CMDRJE Executing B955 10BE The invalid value is specified for the Keep Alive
timer.
CMDRJE Executing B955 10BF The VLAN tagging mode cannot be set because the
VLAN ID has not been entered yet.
CMDRJE Executing B955 10C8 To disable IPv6, delete the remote path for
avoiding the failure of remote copy.
CMDRJE Executing B955 10C9 The same IPv6 address cannot be set to the same
port redundantly.
CMDRJE Executing B955 10CB The number of VLANs exceeds the maximum.
CMDRJE Executing B955 10CD The command cannot be executed because the
specified VLAN ID is already used.
CMDRJE Executing B955 10DB This command cannot be set due to one of the
following reasons:
• The specified value is invalid.
• No option is set when a virtual port in IPv4
mode was added. See the Command Control
Interface Command Reference .
CMDRJE Executing B955 10FB The attribute of the specified port is Initiator or
External.
CMDRJE Executing B955 1201 The command cannot be executed because the
invalid virtual port number has been entered.
CMDRJE Executing B955 1202 The command cannot be executed because the
iSCSI virtual port mode is OFF.
CMDRJE Executing B955 1203 The same IPv6 address cannot be set to the same
virtual port redundantly.
CMDRJE Executing B955 1204 The IPv6 global address 2 cannot be set for the
ports other than virtual port 0.
CMDRJE Executing B955 1205 The command cannot be executed because the
RCU port or the iSCSI name of the iSCSI target for
9-142
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
