Hitachi MICRO-EHV+ - 3.3 I;O Configuration

Chapter 3 Programming
3 – 7
3.3 I/O Configuration
3.3.1 Scan For Devices for expansion units
If expansion units are used, actual I/O configuration can be read out from connected CPU. This operation is not
necessary if only CPU unit is used.
Right click on “Expansion units” and choose “Scan For Devices...”. Then “Scan Devices” dialog appears. Click
“Copy all devices to project”.
N o t e
Be sure to perform “Scan For Devices” after login and logout. “Scan For Devices” works only when logout
however, gateway and active path must be set and opened once in advance.
Instead of “Scan For Devices”, expansion units can be added manually by choosing “Add Device”.