Hitachi PC-ARFH1E - Page 31

22
PMEN0602 rev.0 - 05/2023
1
CONTROLLERCONFIGURATION
PC-ARFH1E FUNCTIONALITIES
• Congure Solar Combinaon opons: Disabled, Input Demand, Total Control. (only in case DHW
is enabled).
• Enable or disable Hydraulic separator status.
• Select Next and press OK buon.

• Congure circuit 1 and circuit 2 opons: Disabled, Points, Gradient, Fix.
• Only available for cooling mode.

• Enable or disable Cascade Mode.
• Congure Central mode opons: Full, water, air or local. Only available when Cascade Mode is
disabled.
• Congure thermostat 1 or 2 (depending on previous sengs): None, wired or wireless.
• Check RT address if wired is selected.
• Select Wireless binding ID (1 or 2) if wireless is selected.
• Select Wizard complete and press OK buon.

• Select Yes to complete the advance conguraon.
• Press OK buon to go to the main screen.