Hitachi PC-ARFH1E - Page 42

33
PMEN0602 rev.0 - 05/2023
1
MAIN SCREEN
PC-ARFH1E FUNCTIONALITIES
The seng temperature can be modied using the arrows keys over this view.
Pressing the OK buon, the following quick acons are shown:
✓ Timer: In this menu, simple mer or schedule mer can be selected and congured.
✓ DHW boost: It acvates the DHW heater for an immediate DHW operaon
✓ Status: Some working condions can be consulted.
If an-legionella operaon is working, its icon appears below the seng temperature.

Swimming pool control
It gives informaon about the swimming pool seng temperature and displays a throughput
icon indicang the percentage of the actual temperature with respect to the seng
temperature.
The seng temperature can be modied using the arrows keys over this view.
Pressing the OK buon, the following opons are shown:
✓ Timer: In this menu, simple mer or schedule mer can be selected and congured.
✓ Status: Some working condions can be consulted.

Unit status signals
This part of the screen displays all the nocaon icons that oer general knowledge on the unit’s
situaon
Some of these icons can be: Defrost operaon, Water pumps, Compressor/s, Boiler working, Tari
input, Night shi, Test run...

Outdoor temperature / Alarm indicaon
In normal operaon, the outdoor temperature is displayed besides the home icon signal.
In abnormal operaon, the alarm icon is indicated with its corresponding alarm code.

Available buons / Installer mode
It indicates the buons of the user controller which can be used in this moment.
When Installer mode is enabled, its icon appears on the right side of this view.