Hitachi PRIMAIDE - FUNCTIONS; Name and Function of Each Part

3.1
3 - 1
3. FUNCTIONS
3.1 Name and Function of Each Part
Fig. 3-1 Front View
• Analog input
connector : For acquisition of analog signals from
the exterior.
• Terminal blocks : Used for input/output of contact signals
(H: high, L: low, G: ground).
(START IN) : For input of start signal to e-Line from
the exterior.
(START OUT) : For output of e-Line start signal.
(BUSY OUT) : For output of busy signal from e-Line.
(AUX OUT) : For acquisition of fraction marker signal
from L-5200 fraction collector.
• CH selector switch : Set to “1” or “2” according to which
channel will use AID.
• LED : Blinks at 1-second cycles during normal
operation (or at 100-ms cycles at
occurrence of an error).
ANALOG
HLG
HLG
HLG
123
CH
Analog input connector
Terminal block (START IN)
Terminal block (START OUT）
Terminal block (BUSY OUT)
Terminal block (AUX OUT)
CH selector switch
LED