APPENDIX - 1
APPENDIX
DESCRIPTION ON CONTACT SIGNAL COMMUNICATION
The following two types of contact signals are used in the
Primaide 1000 series.
(1) Contact signals (START, ERROR, BUSY) entering the
e-Line connector.
These are contact signals having input/output functions that
are used in common for each unit. These signals are
respectively formed from the START (IN/OUT), ERROR
(IN/OUT) and BUSY (IN/OUT) lines.
(START IN, START OUT and BUSY OUT of AID: connect
with the contact signal of e-Line directly.)
(2) Individual contact signals used by each unit.
These are contact signals that are input and output via 3-pin
connector. Their names and functions vary with the unit. A
name that indicates the function is given at each connector.
• Example of output contact signal
EVENT of pump and column oven (Primaide 1310)
• Example of input contact signal
LAMP OFF IN of detector
To Next Page
Loading...
