Change the settings of the Vacuum Compartment
Touch button on the Control Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
Touch button to change the settings as you like.
The display switches in sequence as shown below every time the button is touched.
The temperature is set to
“
-1˚C (Subzero)
”
at the time of purchase.
1
2
※ The above values are obtained with an ambient temperature of 32˚C, the temperature in the Vacuum compartment in a stable state with no
food stored and no door opened.
Touch it
“
-1˚C
”
(At the time of purchase)
“
+1˚C
”
“
Off
”
Non-vacuum (-1˚C)
●
The
“
Off
”
indicator lamp continues to be lit during the
“
Off
”
operation. The display will be turned off
after about 40 seconds for energy saving, but the function that is set once will remain effective.
Caution
● The Vacuum Case is not
put in the vacuum state
unless the handle is
pushed down securely.
●
Closing the door
of the Refrigerator
Compartment without
locking the handle may
damage parts or food or form a clearance between the
doors, which reduces cooling performance.
When opening/closing the door of the Vacuum Case
When opening the door When closing the door
Pull up the
handle to
unlock.
Pull out the
Vacuum Case.
Push the Vacuum
Case back to the
end.
Press down the
handle to lock.
1 1
2
2
Hiss
Handle
Vacuum Case
※
It takes about three to four minutes for the Vacuum Case
to be vacuumed after the vacuum pump starts to operate.
The hissing sound may not be heard when the Vacuum
Case is opened within
four minutes.
※
If you pull out the
Vacuum Case without
opening the door on the
left/right, it may cause
damage to parts.
※
The hissing sound indicates that vacuum is being
released. Thus, the
Vacuum Case cannot be drawn out
while the sound is heard. Draw it out after the sound is no
longer heard.
Caution
VACUUM COMPARTMENT
●
If a part of the gasket is stuck together, the vacuum state cannot be maintained. If it is stuck together,
please remove it. Since it is difficult to see the left and right sides and the bottom, remove the Vacuum
Chilled Case and check it.
Pg.66
● Dew and/or frost may be formed in the sealed Vacuum Compartment due to moisture contained in food or in
the air. Soak a soft cloth in lukewarm water and wipe off the dew and/or frost with the cloth. (Attached dew,
frost or ice does not reduce performance.)
● If you want to avoid dew, frost or ice, stored food should be wrapped with plastic wrap.
● Wipe water or soup spilled in the compartment soon
, if any.
● The platinum catalyst needs no replacement. Do not remove it.
Request
Dew, frost or ice
Gasket
A part stuck together
To Next Page
Loading...
Need help?
General
