Plug the power cord.
It is not a problem to plug in the power cord soon after installing the refrigerator.
Use a wall outlet exclusively when connecting the power cord. (Alternating current 220 - 240V, rated 10A or more)
●
Check that the power plug or the cord is not wedged between the back of the refrigerator and the wall in order to prevent the cord from getting hot.
Cleaning the inside of the refrigerator
Pg.62～65
● Wipe it with a wet and soft cloth and then wipe it with a dry cloth.
● Wash the water supply tank, water filter and ice tray with water.
※ Do not wipe off the lubricant applied to the drawer rail or rail contact surface.
(The lubricant is compliant with the Food Sanitation Act)
※ Initially, the inside may smell like plastic. If you do not like it, ventilate the room so that the smell
does not linge
r for long. (The smell will fade away gradually)
4
3
● Pipes may require rust preventive measures.
If your refrigerator is installed near a hot-spring or industrial area or a sewage pipe, the refrigerator pipe may corrode due to sulfidizing gas. Consult
your dealer. If the pipe is blackened, any failure due to a gas hazard is not covered by our guarantee.
● You will hear an operating sound after inserting the power plug. You may feel that the compr
essor or fan is noisy before the refrigerator is
fully cooled.
● Do not peel off the seal on the back or plastics at the lower part of the side.
● When a magnet or suction cup is attached on the side of the body or the surface of a door, it may leave a mark.
● When you attach a paper sheet on the door surface in a high ambient temperature, dew may form on the door surface,
or the paper may absorb moi
sture.
Notice
Stickers
Plastic parts - Left/Right
Cooling inside the refrigerator starts.
●
It may take more than 4 hours
to cool well the inside of the refrigerator, depending on conditions such as the ambient
temperature or storage state of foods. It may
take 24 hours or more in summer, etc.
Do not put ice cream, uncooled foods or perishable foods in it until the inside of the refrigerator is cooled well.
● Perform
“
Ice Maker Cleaning
”
when using
the automatic ice making function first.
Pg.64
● A series of ice making operation will start automatically after the inside of the refrigerator is cooled well.
(When using for the first time, it may
take 24 hours and more to make ice
.)
● If the inside of the refrigerator has a low temperature, cooling may not start until the elapse of about 10 minutes after inserting the
power plug.
BEFORE USE
■
When opening a door
●
Do not hold the swing partition to open the door.
(It may make it impossible to open the door.)
Open or close a door with a handle.
■
When closing a door
●
Do not close the door with the swing partition erected.
(It may make it impossible to close the door completely.)
Swing partition Swing partition Swing partition Swing partition
Opening or closing a door
Do not apply excessive force to a door, by, for example, opening it with too much force or leaning against the opened door.
Doing so may damage it.
Request
To Next Page
Loading...
Need help?
General
