Water supply container
Once a week
Ice tray
Once or twice a year
Remove the water
supply container,
and then the lid.
Take up the near side of the lid
toward in the direction of the
arrow, and then remove it.
Remove the gasket from
the lid and then the case.
Turn the case and remove it from the lid.
Remove the water filter
from the case.
Pinch the tab of the water filter with
fingers to unset it from the fork, and
then remove the case.
Rinse each part of the water supply
container in water.
Wash it with a soft wash sponge etc.
Do not use the detergents etc.
Attach each part to the water supply
container, pour water
in and then set it.
Insert the lid from its rear side and
close it in the direction of the arrow.
Touch button on the Control
Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are
displayed.
Open the door of the Ice Compartment,
and take out the ice tray.
Push the level laterally. draw the frame.
Raise the cover ( ▲ part) in the direction of the arrow.
Remove the ice tray from the frame.
Empty the ice tray and wash
it lightly in the stream.
Do not use a sponge / cleanser, etc.
Be sure not to scarify.
Open the Ice Compartment, and then
attach the ice tray.
Set the ice tray
Hold down the cover to the end until it snaps.
Push the frame into the rear until the lever slides right.
Move the frame back and forth to check that it is fixed
securely.
Touch button on the Control Panel to turn on
the indicator lamp, and then touch
button to
turn on the
“
On
”
indicator lamp.
Automatic Ice Making starts.
Touch button to turn
on
“
Off
”
indicator lamp.
It stops water supply to the ice tray.
※ When
“
Off
”
indicator lamp blinks,
wait for about 1 minute for it to turn
on, and then follow the next steps.
Note that the frame cannot be pulled out.
1 1
3
4
5
6
2
3
4
5
2
Gasket
Lid
Case
Water filter
Water supply
container
Tab
If you intend not to use the Automatic Ice Maker for an extended period of
time, care the water supply tank, dry it adequately, and replace it in a prede-
termined position (dry out the water filter, among others).
●
If the ice tray frame cannot be pushed into the rear, the motor
that drives the ice-tray may have operated since ice-making is
not set to
“
Off
”
. Remove the ice tray and then push the fra
me
alone into the rear, close the Ice Compartment door, touch
button to enable
“
Off
”
. After about one minute, the ice-
tray driving motor gets ready, allowing you to mount the ice-
tray.
Notice
Notice
Ice tray
Cover
Frame
Lever
Click
Slide
Touch it
Fork
● Replace the water filter normally every 3 - 4 years.
Pg.73
Notice
Slide
Lever
MAINTENANCE
To Next Page
Loading...
Need help?
General
