After one hour, " " disappears from the LCD. After about two hours, the
Press (Frost Wash/Clean) button, " " is displayed on the LCD. Frost
At Frost Wash (Auto) not reserved, " " disappears from the LCD.
At Frost Wash (Auto) reserved, " " is displayed on the LCD.
Recommended time of Frost Wash operation will be informed by " "
(Auto mode) is set. " " is displayed on the LCD.
button, press (Frost Wash/Clean) button on the same, Frost Wash
(Auto mode) is canceled. " "disappears from the LCD.
■
Frost Wash (Manual mode)
■ How to start and cancel Frost Wash (Manual mode).
■ The screen of the remote control
•
Wash operation will start. " " lamp on the indoor unit lights up.
•
indoor unit will stop Frost Wash operation.
• In order to protect the product, Frost Wash function cannot be carried out
again for about 60 minutes after the Frost Wash operation is completed.
•
Press the (START/STOP) button, the operation will stop.
2
1
At the time of the disabled setting, while pressing and holding (Time)
•
Precautions for Use
•
•
Do not open or remove the front panel during Frost Wash operation. It may cause injury or malfunction.
•
If Frost Wash function is not in use for a long period, it may not be
possible to completely wash away the dust and dirt adhering to indoor heat
exchanger. It will cause odor, so please conduct frequently Frost Wash
function by using the remote controller.
•
Frost Wash operation does not wash away all dust and dirt.
•
•
•
•
After turning on the power, please wait a moment if you want to start Frost Wash.
not restart.
•
■ To start Frost Wash (Auto mode)
2
drips down occasionally. This will wet your furniture.
■ To cancel Frost Wash (Auto mode)
button, press (Frost Wash/Clean) button on the same, Frost Wash
1
FROST WASH OPERATION (For single model connection)
•
To Next Page
Loading...
