CLEAN (ONE TOUCH CLEAN) OPERATION
Drying indoor heat exchanger after cooling operation to prevent mildew.
■ To start CLEAN operation
■ To cancel CLEAN operation
NOTE
• When CLEAN operation fi nish, unit will switch OFF automatically.
• If Weekly Timer or Once Timer is set, there is a need to cancel those timer before operating Clean
function.
• For multi connections, when pressing (Frost Wash/Clean ) button, operation is limited to FAN
• For multi connections, when one room operates Clean operation fi rst, other rooms can operate
Cooling, Dehumidifying or Fan operation. However, when other rooms need to operate Heating
operation, air conditioner will be in STANDBY mode. After Clean operation fi nish, Heating operation
will start.
(For multi model connections)
• Press (Frost Wash/Clean) button when unit is OFF.
Total time taken for One Touch Clean operation is 60 minutes.
During this operation, FAN operation shall operate.
During one touch clean, operation lamp is blinking.
“ ” is displayed on the LCD.
• Press (Start/Stop) button.
1
2
operation.
To Next Page
Loading...
