To Next PageTo Next Page
Need help?Do you have a question about the Hitachi RAS-10FSNM and is the answer not in the manual?
General| Cooling Capacity | 2.5 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Weight (Indoor Unit) | 9 kg |
| Energy Efficiency Ratio (EER) | 3.5 |
| Coefficient of Performance (COP) | 3.8 |
| Noise Level (Outdoor) | 50 dB |
| Type | Split System |
General notes and disclaimer regarding the reproduction and accuracy of document content.
Explanation of safety symbols used throughout the manual for hazard identification.
Detailed safety precautions for operating and handling the unit.
Further safety guidelines related to specific conditions like refrigerant handling.
Guidelines for safely transporting the unit to the installation site.
Essential checks and procedures to perform before starting the unit.
Specific instructions for installing the outdoor unit correctly.
Requirements for ensuring adequate space around the unit for installation.
Guidelines for preparing the installation location.
Specifications for piping materials used in the system.
Procedure for connecting piping to the outdoor unit.
Procedure for testing the system's airtightness.
Instructions for charging the system with refrigerant.
Safety precautions when checking pressure at the joint.
Guidelines for maximum allowable HFC refrigerant concentration.
Pre-wiring checks for electrical components and compliance.
Procedure for connecting electrical wiring to the outdoor unit.
Wiring instructions between indoor and outdoor units.
Guidelines for wire sizing and main breaker selection.
DIP switch settings for PCB1 on the outdoor unit.
Setting DSW1 for compressor test and service.
Setting RSW1 for refrigerant cycle number.
Setting DSW2 for optional functions.
Setting DSW3 for system capacity.
Procedure for performing a test run using the remote control.
Details on compressor protection mechanisms.
Details on AC fan motor protection mechanisms.
