10 Servicing
382
SMGB0087 rev.0 - 12/2013
10.4.15 Removing electrical components
10.4.15.1 Removing control PCB (PCB1)
1 Remove the service cover following “10.4.1Removingser-
vicecover”.
2 Remove all the wiring connected to the control PCB.
3 Remove the 6 holders. Clamp the middle part of the holders
with long-nose pliers and remove it toward front side.
Holder
Printed Circuit Board (PCB1)
10.4.15.2 Removing Inverter module
1 Remove the service cover following “10.4.1Removingser-
vicecover”in this chapter.
2 Open the P plate turning counter clockwise approximately
90° following “10.4.9Openingelectricalbox(Pplate)”.
3 Check that the LED201 (red) on Inverter is OFF when the
P plate is opened. Remove all the wiring connected on the
Inverter.
4 Remove 4 screws which x the Inverter.
Hold the wires placed at the bottom side.
5 Pull the Inverter toward right side from the front of the pro-
duct. (Remove along with the plastic case and the radiation
n).
To Next Page
Loading...
