Hitachi RC-AGS1EA0E - airCloud Home Module Initialization; Restoring Factory Settings and Notes

 You can reset the internal settings (restore the factory settings) by remote controller.
NOTE
• Please note that the configuration will be cleared and pairing procedure
will be required to do again to use the built-in airCloud Home module.
• Please refer separate operation manual available for more information
related Built-in airCloud Home Module.
Initialization of the Built-in airCloud Home Module
How to restore factory setting■
Please make this setting with the remote control in off mode.




Press button (Mode) and button (On Timer) 3 seconds
together.
LCD will display “
” on Temperature segment for 3 seconds
then it will display normal screen.
Make sure “ ” Lamp on the indoor unit flash 4 times repeatedly
for about 20 seconds.
Restart the unit & check “
” Lamp blinks 3 times. This ensures
"Wi-Fi" is a trademark or registered trademark of the "Wi-Fi Alliance".
that unit enters into pairing mode & restoring factory setting is
succeeded.
-22--23-