My Mode(Programming)
Programming of My Mode
On Timer Setting
Press ( Timer ON) Button to select ON timer.
Symbol start blinknig on LCD screen.
ON Timer time will be display on clock time segment on LCD.
Press button to set desire ON timer.
Press button . It will set ON timer programming.
symbol stop blinking on LCD screen.
Remote controller will go to ON mode after ON timer elapse.
To cancel ON timer , Press On Timer button and Off Timer button
together for 3 seconds.
●
●
●
6
Register of My Mode Programming
8
● Once all desire setting completed , press (On/Off) button during
" " blinks.
All selection will be saved to remote controller and room air conditioner.
●
Off Timer Setting
Press ( Timer OFF) Button to select OFF timer.
Symbol start blinknig on LCD screen.
OFF Timer time will be display on clock time segment on LCD.
Press button to set desire OFF timer.
Press button . It will set OFF timer programming.
symbol stop blinking on LCD screen.
To cancel Off timer , Press On Timer button and Off Timer
button together for 3 seconds.
Remote controller will go to OFF mode after OFF timer elapse.
●
●
7
●
●
●
●
●
●
●
●
If operation of remote controller will not be done for 10 seconds during My Mode programming, remote controller
will come out from My Mode programming without registering of My Mode Programming.
W
ithout registering of My Mode Programming, My Mode selection will remain with all previously selections
and
previous values.
If My Mode button is kept pressing for 5 seconds during My Mode Programming, remote controller will come
out from My Mode programming.
W
ithout registering of My Mode Programming, My Mode selection will remain with all previously selections
and
previous values.
If battery is replaced or (Reset) button is pressed, My Mode Programming on remote controller will be
reset to default settings.
I
f new settings are required, do My Mode Programming again.
When Operation Mode Lock is set, selectable mode during My Mode will be limited.
To Next Page
Loading...
