Hitachi RC-AGU1EA0G - My Mode Programming; Initiating and Selecting Mode; Configuring Operation Settings

Enter to My Mode programming
●
Press the My Mode button continuously for 5 seconds .
●
“ ” blinks on the LCD. And “ ”, “ ” or “ ” appear at the right of “ ”.
The blinking of “
By pressing the
” will remain for 10 seconds.
●
(My Mode) button, “ ”, “ ” or “ ” can be
selected for programming.
My Mode(Programming)
● Use this mode for personalized comfortable settings. The My Mode can be set by using the remote controller.
● Up to 3 programs can be set.
Default Setting of My Mode
Programming of My Mode
My Mode Mode Temperature Fan Speed SilentON Timer /
OFF Timer
My Mode1 COOL 25.℃ Auto
No setting No setting
My Mode2 COOL 25.℃ Auto
No setting No setting
My Mode3 COOL 25.℃ Auto
No setting No setting
Mode Selection
Press (Mode) button in order to select desired Mode during “ ”
(Heat) (Auto) (Cool) (Dry)
blinks.
Mode will change from
(Fan) cyclically.
●
●
Fan Speed Selection
Press (Fan Speed) button in order to select desired Fan Speed
during “ ” blinks.
Available Fan speed only can be selected as per selected desired mode.
●
●
Desired Room Temperature Selection
Press button or button in order to select desired Room
Temperature during “ ” blinks.
Temperature range can be set between 16.0℃ and 32.0℃.
Fan Mode can not be set desired Room Temperature.
●
●
●
Silent Mode Selection
Press (Silent) button in order to set or cancel Silent Mode during
“ ” blinks.
●
- 16 -
11
12
13
14
15