Hitachi RC-AGU1EA0G - My Mode Timer and Registration; Setting On and Off Timers; Registering My Mode Settings; My Mode Programming Notes

My Mode(Programming)
Programming of My Mode
On Timer Setting Selection
Press (On Timer) button in order to select On Timer setting during
“ ” blinks.
“ ” blinks on the LCD.
Setting time will change according to the below sequence when you press
the button.
●
●
Set Temp. -0.5Hr. -1.0Hr. -2.0Hr-3.0Hr.......... -10.0Hr. -11.0Hr -12.0Hr.
Off Timer Setting Selection
Press (Off Timer) button in order to select Off Timer setting during
“ ” blinks.
“ ” blinks on the LCD.
Setting time will change according to the below sequence when you press
the button.
●
●
Set Temp. -0.5Hr. -1.0Hr. -2.0Hr-3.0Hr.......... -10.0Hr. -11.0Hr -12.0Hr.
If operation of remote controller will not be done for 10 seconds during My Mode programming, remote controller
will come out from My Mode programming without registering of My Mode Programming.
without registering of My Mode Programming, My Mode selection will remain with all previously selections and
previous values.
If My Mode button is kept pressing for 5 seconds during My Mode Programming, remote controller will come
out from My Mode programming.
without registering of My Mode Programming, My Mode selection will remain with all previously selections and
previous values.
If battery is replaced or (Reset) button is pressed, My Mode Programming on remote controller will be
reset to default settings.
if new settings are required, do My Mode Programming again.
When Operation Mode Lock is set, selectable mode during My Mode will be limited.
●
●
●
- 17 -
6
7
Register of My Mode Programming
8
● Once all desire setting completed , press (On/Off) button during
" " blinks.
All selection will be saved to remote controller and room air conditioner.
●
Cancel OFF Timer
Cancel ON Timer