FEATURES
1-22
TCI-20007-rev.1
z
System Example (PSC-A64GT)
This central station (PSC-A64GT) is connected to H-LINK and used for the central control and
monitoring of the air conditioners. The system conguration example is shown below.
NOTES:
1. Turn OFF all the power supply of the indoor unit and the outdoor unit before dip switch setting.
If not, the setting is invalid.
2. Do not set the same indoor unit number in the same refrigerant cycle.
If the same number exists, the alarm code of “35” will appear.
1 2
ON
1 2
ON
1 2
ON
Central Station
(PSC-A64GT)
Controlled by Central Station
(Remote Control Group)
Wiring for
Wired Controller
Without
Transition
Wiring
With
Transition
Wiring
Max. 8 Units in the same H-LINK are available.
Max. 64 Remote Control Groups and Max. 160 Indoor Units are available.
(For H-LINK II Only)
Without
Wired
Controller
Without
Wired
Controller
H-LINK
Transmission
Wiring
Terminal Resistance Setting DSW5
Refrigerant No. Setting
Refrigerant No. Setting
Indoor Unit No. Setting
Group No.
Group
1
1 1 2 2 3 3
0 1 0 1 0
1
2 3
Group Group Group
To Next Page
Loading...
