Hitachi RPC-4.0FSR - Operation Method; Setting Method; Operation; Operation Lock

Connecting Rod
Louver
Vertical Deflector
1 Set
●

AdjustingVerticalDeector
Theverticaldeectorswhichconsist3setsof
deectorareconnectedbytheconnectingrod.
Adjusttheverticaldeectorsbyhandtothe
requireddirection.Toadjustthem,stopswinging
thelouverduringtheoperation.
●

SwingLouverDirectionduringHeatingOperation
●

AutomaticSettingofLouver
 Theswinglouverisstoppedandmovedby
controllingthewiredcontroller.
When“Stop”switchispressedfromthewired
controller,theswinglouverwillbeclosed
automaticallyandtheoperationisstopped.
●

When“RUN”switchispressedfromthewired
controller,theswinglouverwillbeopened
automatically.Atthistime,forcooling,dryand
fanoperation,theindoorunitisoperatedwith
thesettemperatureafterthefanspeed“SLOW”
operationisperformedforapproximately20
seconds.
Duringtheheatingoperation,themovementis
sameas“HotStartduringHeatingOperation”.
(Refertotheitem11.)
Horizontal
* Whentheheatingoperationstarts
* Whenthedefrostoperationstarts
* Whenthermo-controlleractivates
 Thelouverangleisxedhorizontally.
 Whenthedischargetemperatureis
higherthan30
o
C,thelouverangleis
automaticallyreturnedtothesetting
condition.
CAUTION
Do not move the louver by hand. If moved, the
louver mechanism will be damaged and the air
ow direction may not be set.
Louver
Do not move
the louver by hand.
6. Operation
RefertotheoperationmanualofPC-ARF1.
7. Operation Lock
RefertotheoperationmanualofPC-ARF1.
8. Menu Operation
RefertotheoperationmanualofPC-ARF1.
A10762290A
9
4. Operation Method
RefertotheoperationmanualofPC-ARF1.
5. Setting Method
RefertotheoperationmanualofPC-ARF1.