Hitachi RPC-5.0FSR - Indoor Unit Installation; Factory-Supplied Accessories

A10762300A-rev.1
9
4. Indoor Unit Installation
4.1 Factory-SuppliedAccessories
Checktoensurethatthefollowingaccessoriesare
packedwiththeindoorunit.
Thehoseclamp,screws,washersandcordclamps
areputinthepipeinsulation.
Table4.1Factory-SuppliedAccessories
NOTE
● Do not put any foreign material into the
indoor unit and check to ensure that none
exists in the indoor unit before the installation
and the test run. Otherwise, a re or failure,
etc. may occur.
● Check to ensure that the ceiling is strong
enough. If not strong enough, the indoor unit
may fall down on you.
● Do not install the indoor unit to outdoors.
If installed, an electric hazard or electric
leakage will occur.
Do not install the indoor unit in a ammable
environment to avoid re or an explosion.
•
Ifanyoftheseaccessoriesarenotpackedwith
theunit,pleasecontactyourcontractor.
•
Thewiredcontrollerandthebranchpipesare
optionalaccessorieswhicharenotincludedwith
theindoorunit.
Accessory Q’ty Purpose Usage
SuspensionBracket
2 ForMountingIndoorUnit
Refertotheitem4.3.3.
Washer
8 ForSuspensionBracket
PipeInsulation
(Large)
1
ForRefrigerantPiping
Connection
Refertotheitem5.2.2.
PipeInsulation
(Small)
1
CordClamp
(Large)
6 ForFixingInsulation
CordClamp
(Small)
1 ForFixingPlug
Refertotheitem6.
DrainHose
1 ForConnectingDrainPipe
HoseClamp
2 ForConnectingDrainHose
Insulation
2 ForDrainHoseConnection