2-88
SERVICING
(2.6 Wall Type)
Phillips ScrewdriverTool
TURN OFF all power source switches.
(5) Release the catch holding the left side of the heat exchanger and remove one screw fixing the heat
exchanger.
2.6.8 Removing Heat Exchanger
(1) Remove the front panel according to the item 2.6.2 “Removing Front Panel”.
(2) Remove the electrical box according to the item 2.6.5 “Removing Electrical Box Cover”.
(3) Remove the drain pan according to the item 2.6.7 “Removing Drain Pan”.
(4) Remove the piping stay at the rear side of the indoor unit.
Heat Exchanger
Piping Stay
Rear Side of Indoor Unit
Screws
Rear Piping of Heat Exchanger
Screw
Release Catch
To Next Page
Loading...
