Hitachi S1-00073HFE - Page 130

S1 series standard inverter
-125-
Function
code
Name
Detailed parameter description
Default
value
Modify
P06.22–
P06.26
Reserved
variables
0–65535
0
●
P06.27
Lower limit of
HDO output
-100.0%–P06.29
0.00%
○
P06.28
Corresponding
HDO output of
lower limit
0.00–50.00kHz
0.00kHz
○
P06.29
Upper limit of
HDO output
P06.27–100.0%
100.0%
○
P06.30
Corresponding
HDO output of
upper limit
0.00–50.00kHz
50.00
kHz
○
P06.31
HDO output filter
time
0.000s–10.000s
0.000s
○
P07 group Human-Machine Interface
P07.00
User password
0–65535
Set it to any non-zero value to enable password
protection.
00000: Clear previous user password and disable
password protection.
After user password becomes valid, if wrong
password is inputted, users will be denied entry. It
is necessary to keep the user password in mind.
Password protection will be effective one minute
after exiting function code edit state, and it will
display "0.0.0.0.0" if users press PRG/ESC key to
enter function code edit state again, users need to
input the correct password.
Note: Restoring to default values will clear user
password, use this function with caution.
0
○
P07.01
Parameter copy
0: No operation
1: Upload the local function parameter to the
keypad
2: Download the keypad function parameter to
local address (including the motor parameters)
3: Download the keypad function parameter to
local address (excluding the motor parameter of
P02 and P12 group)
4: Download the keypad function parameters to
local address (only for the motor parameter of
P02 and P12 group)
0
◎