Hitachi SH1-900H

4-2
Chapter 4
Settings
4.1.2 Code display system
Note: The display contents on the monitor depend on the setting of function “UA-10”(function code display restriction),”UA-91”
(initial-screen selection),and”UA-30”(automatic setting of user parameters).
Item
Function code
Data
Description
Function code display
restriction
UA-10
00
Full display
01
Function-specific display
02
user setting
03
Data comparison diaplay
04
Basic diaplay (factory setting)
Initial-screen selection
(Initial display at
power-on)
UA-91
(*1)
dA-01
Output frequency monitoring (factory setting)
dA-02
Output current monitoring
dA-03
Rotation direction monitoring
dA-06
Scaled output frequency monitoring
FA-01
Output frequency setting
Selection of automatic
user-parameter settings
UA-30
(*1)
00
Disable (factory setting)
01
Enable
(*1) Not displayed with the factory setting。
※The following procedure enables you to turn the monitor display back to or
Hold down the key for 4 seconds or more.The monitor shows .
During this status,press the key.The monitor will show .
Note:The monitor shows only when the motor driven by the inverter is stopped.While the motor is
Running,the monitor shows an output frequency.
The initial display on the monitor screen after power-on depends on the setting of function”UA-91”.When the setting of function”UA-91”=
“dA-01”(factory setting),the monitor initially show ， as the setting of “dA-01” . Pressing the key in this status changes
The display to .
,
FUNC
FUNC
FUNC

.




.
.

.