English - 20 -
supported by the browser.
Your Display does not support any download
processes from the internet via the browser.
All sites on the internet might not be supportted.
According to the site; content problems may occur.
In some circumstances video contents might not be
able to be played.
Internal USB Operations
Your Display has an internal memory. There are 4
operations available that can be performed with the
internal memory: Copy From USBCopy To USB
Delete and Format Disk (FAT32 only).
These options can be found in the Signage
Settings>Internal USB operations menu.
The internal memory of your Display has a default
int_usb
Copy From/To USB operations are performed using
this folder. If you want to copy data from an external
USB storage device to the internal memory of your
copy_to_int_usb
of the external USB storage device. If you want to
copy data from the internal memory of your Display
copy_from_int_usb
directory of the external USB storage device.
Copy From/To USB operations will only be available
if a USB storage device is connected to your Display.
Delete and Format Disk
even if no USB storage device is connected. The
int_usb
internal memory will be automatically recreated after
each time Delete and Format Disk operations are
performed.
OSD Rotation Support (*)
You can change the OSD (On Screen Display) rotation
of your Display if desired. While performing First
time installation set the OSD Orientation option
as desired when the Signage Settings menu is dis-
played. You can also change this setting later from the
Signage Settings>Controls menu. Available options
are: Landscape and Portrait.
(*) This feature may not be available depending on the model
of your Display
DisplayPort
DisplayPort version 1.2 is supported via the Display-
Port input and output connectors on your Display.
DP Stream Setting option in the System>Set-
tings>More menu is set as MST(Multi-Stream Trans-
port) by default. If a MST compliant source device is
If DisplayPort version 1.1 compliant or SST (Single-
Stream Transport) compliant source device with
DisplayPort version 1.2 support is connected to the
in all connected Displays.
To be able to stream the same image to all connected
DP Stream
Setting option in the System>Settings>More menu
should be set as SST.
The maximum amount of the Displays that can be
connected by using daisy-chaining function may differ
capable of supporting this operation.
Note: It is recommended to use a DisplayPort certied cable
for connection.
In SST operation mode the total amount of the Displays is
limited (a maximum of 7 units) due to HDCP encryption. If
the signal is stable and there is no cable loss, there will be no
limitation in case the source content is not HDCP-encrypted.
When using cascade-connected Displays, it is recommended
to set the DP Stream Setting as SST on all Displays in SST
operation mode.
For proper operation in MST operation mode make sure your
source device is MST compliant. If your source device is a
computer check the specications of its graphic card to ensure
MST compatibility. When using daisy-chained Displays, it is
recommended to set the DP Stream Setting as MST on all
Displays in MST operation mode.
To Next Page
Loading...
Need help?
General