English - 25 -
BROWSER COMMANDS
Command Description Parameter Return
OPENURL
Starts the given URL and
returns web page load
status directly.
string-integer n <load
url='n' />
#*status= ... url=n
GETURL
Gets URL of the current
page if the portal is active.
no parameter #*URL : ...
GETUSERAGENT
Gets portal user agent. no parameter #*Current UA : ...
GETCURSORPOSITION
Gets cursor position in the
browser.
no parameter #*X: ... Y: ...
SETCURSORPOSITION
Sets cursor position in the
browser.
#*X: a Y: b
SETSETTINGSURL
Sets the settings URL string #*Setting URL is set
GETSETTINGSURL
Gets the settings URL no parameter #*Setting URL is ...
SETSTARTURL
Sets the start URL string #*Start URL is set
GETSTARTURL
Gets the start URL no parameter #*Start URL is ...
GENERAL DISPLAY COMMANDS
Command Description Parameter Return
SETRC
Enables/disables remote
control commands.
= OFF)
set remote state On or set remote
state OFF
SETSOURCE
Set source as enable/
disable.
"#*Selected source n
#*Enable/Disable state : b"
GETSOURCE Gets source. no parameter #*source is ...
GETCOUNTRY
Get country in channels
state.
no parameter #*COUNTRY IS : ...
GETSWVERSION
Returns the software
version of tv.
no parameter #*V...
KEY Send key to Eclipse.
.....ext.)
n key send to Eclipse
RESET Reset the device. no parameter
Reset process was successfully
accomplished. You need to
establish the connection again.
STANDBY
Switch display to hard
standby.
(Note: Don’t use this com-
mand with the product
that has OPS. You can
use other “KEY standby”
command.)
no parameter
"#*enterLowPowerMode() returns
successfully.
or
#*enterLowPowerMode() returns
unsuccessfully!
or
#*enterStandbyMode() returns
successfully.
or
#*enterStandbyMode() returns
unsuccessfully!
"
To Next Page
Loading...
Need help?
General