Getting Started - 15 -
Removing the Battery Pack
1. Lift the OPEN lever and pull it up. The power supply attachment cover will open.
2. Push the side of the battery in the direction of the arrow. A click will be heard and the battery is released.
3. Remove the battery and close the cover.
Checking the Battery's Charge
A battery charge indicator is located on the upper right corner of the viewfinder. One of three symbols displays
when the battery is used.
This symbol indicates a fully charged battery.
This symbol indicates a partially charged battery.
This flashing symbol indicates a battery nearly out of power. Use an alternate power source or
charge the battery before continuing to use the camcorder.
Using Alkaline Dry-Cell Batteries
The camcorder can be powered by six alkaline dry-cell batteries inserted into the power supply attachment holder.
The continuous operation time of the camcorder depends on the type of alkaline batteries used. Please ensure
that CAM/OFF/VIDEO switch is in the OFF position whenever attaching or detaching any power supply (i.e.
Battery, AC adapter/charger, etc.)
1. Lift the OPEN lever and pull it up. The power supply attachment cover will open.
To Next Page
Loading...
Need help?
General
