to download and install the Hitachi Remote Ops monitoring system.
Before you begin
• Register an account on the Support Website.
Procedure
1. Locate the product serial number (labeled MFG. NO.) on the rear of the controller. You will need this number to
register your storage system.
2. Open a web browser on your PC or mobile device.
3. Log in to the Support Website, and follow the instructions to register your storage system. If you have previously
registered Hitachi Vantara products, you can add an additional site.
Step 9: Install Hitachi Remote Ops monitoring system
Hitachi Remote Ops monitoring system monitors your storage system and notifies Hitachi Vantara when service is
required. Hitachi Remote Ops runs on Windows, Linux, and Solaris operating systems.
Before you begin
• Log in to the Support Website. If you do not already have an account, you need to register. When registering, you
will be asked for information about the product. For Product Name, enter VSP E Series. The product serial number
is labeled MFG. NO. on the rear of the controller.
• Obtain the Site ID for the location at which the storage system is installed. If you do not see your site listed, you will
first need to add the site.
Procedure
1. Download the Hitachi Remote Ops system software and documentation.
2. Follow the instructions in Hitachi Remote Ops Installation Guide to intall and configure Hitachi Remote Ops.
3. After you have configured Hitachi Remote Ops with the appropriate Site ID, open a case on the Support Website
to let us know that your system is installed and that the Hitachi Remote Ops monitoring system is enabled.
Installing Hitachi Remote Ops completes the self-installation of your storage system.
Where to go from here
When installation and configuration are complete, the storage system is ready for use.
https://knowledge.hitachivantara.com/Documents/Storage/VSP_E_Series/93-04-0x/Installation/Installing_your_VSP_E590_an…
Updated: Thu, 06 Jan 2022 00:49:25 GMT
Powered by
17
To Next Page
Loading...
