Hitachi VSP F370 - Step 5: Power on the Storage System

Item Description
1 Management port on the rear of controller 1
2 Management console
3 Management network
2. Connect the other end of the cable to a management (non-production) network.
3. Connect the management console to the same management network.
Step 5: Power on the storage system
Procedure
1. Power on the PDUs.
2. Conrm that the top (POWER) LED on the lower left front side of the controller is lit
amber, as shown in the following gure. If the storage system has a drive tray,
conrm that the POWER LED on the lower left front side of the drive tray is lit green.
Step 5: Power on the storage system
Installing your storage system
Storage system installation (without SVP) 13