HITEC OPTIC6 SPORT2.4

Need help?

Do you have a question about the HITEC OPTIC6 SPORT2.4 and is the answer not in the manual?

Summary

Introduction to the Optic 6 Sport

If you are new to Computerized RC Transmitters

Guidance for first-time users of programmable RC transmitters.

Model Memory

Explains the transmitter's ability to store settings for multiple aircraft models.

Buddy-Box Function

Describes using a trainer cord to connect two transmitters for instruction.

Pre-post Flight Controls

Details on essential pre-flight checks and post-flight procedures for aircraft.

Flying Safety

Optic 6 Sport Controls and Switch Assignments

Transmitter Displays and Messages

Warning Display (Low voltage)

Alerts the user when the transmitter battery voltage is critically low.

Initial Setup Menu Programming for All Aircraft

Model Setup Menu Programming for Powered Airplanes (ACRO)

EPA (End Point Adjustment)

D;R (Dual Rate)

EXP (Exponential Rate)

S TRM (Sub Trim)

S REV (Servo Reverse)

P MIX (Programmable Mix)

Set up a throttle-to-rudder mix

Creating a mix to automatically apply rudder during throttle changes.

ELVN (Elevon mix)

FLPN (Flaperon)

Create aileron differential

Setting different travel for up and down aileron movement.

V.TAL (V-Tail)

A -> R (Aileron-Rudder Mix)

E-F (Elevator-Flap Mix)

CUT (Engine Cut Function)

CAMB (Wing Camber)

FLT C (Flight Conditions)

Initial Menu Feature Review for GLID Programming

Model Setup Main Menu Programming

CROW (Glide-Path and Airspeed Control)

CAMB (Wing Camber)

Optic 6 Sport Manual for Helicopters

Initial Menu feature review for HELI programming

Model Setup Menu Programming

T.CV (Throttle Curve)

P.CV (Pitch Curve)

GYRO (Gyro Gain)

HOLD (Throttle Hold)

RVMX (Revolution Mix)

SWAH (120 Swash Plate Programming)

FLT.C (Flight Conditions or Idle-Ups)