Need help?Do you have a question about the HITEC OPTIC 6 and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| Modulation | PPM |
| Power Supply | 9.6V |
| Display | LCD |
| Frequency | 72MHz |
| Battery Type | NiMH |
| Dimensions | 190 x 80 x 220 mm |
Instructions on battery charging and monitoring.
Procedures for turning on/off equipment safely.
Diagram and explanation of transmitter controls and switch assignments.
Explains low battery, idle on, and hold on warnings.
Step-by-step setup for an aerobatic airplane.
Detailed setup steps for an aerobatic airplane.
How to adjust subtrims for servo neutrals.
How to set dual rate values for controls.
How to use programmable mixers (PMX1, PMX2).
Setting servo travels for each channel.
Setting dual rates and exponential.
Diagram of transmitter controls and switch assignments.
Detailed explanation of End Point Adjustment (EPA).
Detailed explanation of Servo Reversing (REV).
Detailed explanation of Flap Travel (FLPT) function.
Detailed explanation of Aileron Differential (ADIF).
How to set up Aileron Differential (ADIF).
Detailed explanation of Elevon Mixing (ELVN).
Detailed explanation of V-Tail Mixing (VTAL).
Detailed explanation of Aileron-Rudder Mixing (A->R).
Detailed explanation of Crow Mixing (Airbrakes).
Detailed explanation of Programmable Mixes (PMX1, PMX2).
Details on setting up the Ailevator function.
Detailed explanation of Failsafe Function.
Detailed explanation of Subtrim (S.TRM) settings.
Detailed explanation of Throttle Cut (T.CUT).
Detailed explanation of Flaperon Mixing (FLPN).
Detailed explanation of Camber Control (CAMB).
Detailed explanation of Ailevator Function.
Diagram of helicopter controls and switch assignments.
Checking and setting servo directions.
Description of flight conditions (NOR, ST1, ST2, ST3).
Explanation of End Point Adjust (EPA).
Explanation of Dual Rates (D/R).
Explanation of Exponential (EXP).
To Next Page
