Need help?Do you have a question about the HITEC ECLIPSE 7 and is the answer not in the manual?
General| Brand | HITEC |
|---|---|
| Model | ECLIPSE 7 |
| Category | Remote Control |
| Language | English |
Instructions and precautions for charging transmitter and receiver batteries.
Recommendations for choosing and using a flying field safely.
Safety procedures to follow upon arrival at the flying field.
Guidelines for mounting and checking servo operation and linkages.
Table showing servo hookups for different model types (Aircraft, Glider, Helicopter).
Explains warning messages like Low Battery, Idle On, and Hold On.
Describes functions for selecting model memory, type, and other setup options.
Setting servo directions and checking initial movement.
Adjusting servo travel limits (EPA) for each channel to prevent binding.
How to set or limit the travel of each servo for different directions.
Steps to program custom mixing functions between channels.
Checking servo connections, model memory, type, and name for gliders.
Steps to program custom mixing functions between channels.
Choosing the model type as HELI to access helicopter-specific functions.
Selecting the swashplate type (NOR, 120', 180') based on the helicopter's mechanics.
Checking and reversing servo operating directions for proper helicopter control response.
Setting servo neutrals using subtrims for precise hovering control.
Setting collective pitch angles for different flight conditions.
How to set or limit the travel of each servo for different directions.
Adjusting control response sensitivity using dual rate switches.
Adjusting servo response curves for smoother control around neutral.
To Next Page
