HITEC ECLIPSE 7 - Table of Contents

Aircraft
(ACRO)
Section
– 31 –
ACRO Functions Map.......................................... (see right)
Simple Aerobatic Airplane Transmitter Setup...............32
EPA............End Point Adjust (servo travels)......................41
D/R............Dual Rates........................................................42
EXP............Exponential Settings.........................................43
FLT.C ........Flight Condition Select.....................................44
STRM .........Subtrim.............................................................47
REV............Servo Reverse ..................................................47
T.CUT ........Throttle Cut (engine shut off) ..........................48
PMX1-5......Programmable Mixer #1 – #5 (five total) ........49
LAND .........Landing function settings.................................50
FLPT .........Flap trim...........................................................51
E->F .........Elevator
→Flap mixing.....................................52
A->R .........Rudder Coupling..............................................52
ELVN .........Elevon mixing (tailless models) .......................54
VTAL .........V-tail mixing.....................................................55
FLPN .........Flaperon (combined flaps & ailerons)..............57
Aircraft Trimming Chart .................................................60
Dual Rate Set
[D/R]
End Point Adjust
[EPA]
Press both
Edit/Display keys
Ail
→
Rud Mix
[A-R]
Flap Trim
[FLTR]
Landing
[LAND]
Elev
→
Flap Mix
[E-F]
Prog. Mix 1-5
[PMX-]
Flight Cond.
[FLT.C]
Elevon Mix
[ELVN]
V-Tail Mix
[VTAL]
Exponential
[EXP]
Sub-Trims
[STRM]
Servo Reversing
[REV]
Throttle Cut
[T.CUT]
Flaperon Mix
[FLPN]
Normal Display Mode
Voltage/Timer Display