Aircraft
(ACRO)
Section
– 25 –
COPY
4213567
MODEL
Current No.
SLV
MAS
Destination
(flashing)
3. The source model memory (the memory that will be duplicated) is the current one, indicated
by the fixed upper arrow. To select your destination model number, press the
Left
or
Right
Cursor
keys. The selected destination memory number is shown by the flashing triangle
under it.
4. Press the
+Increase
and
–Decrease Data
keys at the same time. The transmitter beeps twice
rapidly, indicating the copy has been completed. THIS WILL ERASE ALL THE OLD
SETTINGS IN THE SLAVE MODEL MEMORY, SO BE SURE YOU’RE IN THE
CORRECT MODEL BEFORE YOU COPY MODEL!
5. Switch power off.
6. Switch power back on. If you wish to go to the newly-saved memory, repeat step 1.
ACRO
,
HELI
,
GLID
— Model Type Select
This function is used to select the type of model to be programmed in the current model
memory. You may select from aircraft (ACRO), gliders (GLID), and helicopters (HELI). If you
select glider or helicopter types, you will need to set the wing type (for a glider) or the swash type
(for a helicopter). These settings are covered below.
Selecting the Model Type
1. With the transmitter switched off, turn on your transmitter while pressing both of the two
Edit
keys (the two keys on the far left). The model select (M.SEL) menu will be displayed.
2. Press the
Down
arrow key. This gets you into the type select menu. The current model type
will be flashing on and off. (If you’re already in the setup menus, you can just press the
Up
or
Down
arrow key to get here.)
ACRO
4213567
MODEL
flashing
GLID
4213567
MODEL
flashing
HELI
4213567
MODEL
flashing
3. If the model type you want is displayed, you’re done. [If you wish to change the wing type
or swash type in the GLID and HELI model settings, see the sections below.]
4. If you wish to change the model type from that displayed, press on the
Left
or
Right
Cursor
buttons until the model type you want, either ACRO, GLID, or HELI, appears.
5. To select your desired model type, press both the +
Increase
and –
Decrease
Data
keys
simultaneously. Two beeps tell you that the new model type is now registered. THIS WILL
To Next Page
Loading...
Need help?
General
