– –
30
2. Press the
Up or Down
arrow key until you get into the Reset (REST) menu. This display has
the word “REST” flashing on and off. (If you’re already in the setup menus, you can just
press the
Up
or
Down
arrow key to get here.)
REST
421 3 567
MODEL
3. IF YOU ARE SURE YOU WANT TO RESET and clear out the current model memory, press
both the +
Increase
and –
Decrease
Data
keys at the same time. The transmitter will beep
twice to indicate a successful reset
4. Press the
Up
or
Down
arrow keys to get to another setup menu, or switch power off.
5. Switch power back on. You may now set up the details of your model in the Edit mode.
CAUTION: WHEN YOU COMMAND
RESET
, YOU’LL ERASE THE MEMORY
YOU’RE IN AND LOSE ANY PROGRAMMING YOU HAVE ENTERED. DON’T DO
THIS UNLESS YOU ARE POSITIVE YOU WANT TO FLUSH OUT THAT MEMORY
AND START FROM SCRATCH WITH THE FACTORY DEFAULT SETTINGS.
AIRCRAFT (
ACRO
) MENU FUNCTIONS
This section describes the menu functions for fixed-wing aircraft, provides a detailed
setup example, and then describes the functions individually. Functions relating
specifically to gliders and helicopters may be found in the following sections.
To Next Page
Loading...
Need help?
General
